|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
01-11-2019, 08:59 AM | #1 |
Senior Member
Join Date: Oct 2014
Location: Maine
Posts: 224
|
Handle Restoration
Reading an old "Model A News" January/February 2007 I came across an article by Tim Johnstone, on Inside Door and Window Regulator Handle Restoration. The article was well written, however it referenced an article in the "Restorer" from November/December 1980 that would described how to make a new bushing for the handle with no further explanation. Does anyone have the November/December 1980 issue of the "Restorer"? I am primarily interested in the article by Jim Boehmke on making new bushings for the door and window handles.
Seems like a great winter project. |
01-11-2019, 09:49 AM | #2 |
Senior Member
Join Date: May 2010
Location: Eastern Tennessee
Posts: 11,513
|
Re: Handle Restoration
Check your PMs.
|
Sponsored Links (Register now to hide all advertisements) |
|
01-11-2019, 01:30 PM | #3 |
Senior Member
Join Date: Aug 2010
Location: Port Orchard, WA
Posts: 1,498
|
Re: Handle Restoration
Here are the pages from The Restorer magazine November - December 1980
__________________
1931 160B & 1931 68B If you don't have time to do it right the 1st time, how do you have time to do it the 2nd time? |
01-12-2019, 06:54 PM | #4 |
Senior Member
Join Date: Jun 2015
Location: Signal Mtn, TN (SE TN)
Posts: 2,371
|
Re: Handle Restoration
You can buy sq hole sleeve from Essentra what used to be Reid Supply in PA
Surely there are better machinist than me but what is shown in the PDF attachments didn't work as well as I hoped. Last edited by Oldbluoval; 01-12-2019 at 07:18 PM. |
06-24-2019, 07:33 AM | #5 |
Senior Member
Join Date: May 2010
Location: Williamsburg, VA
Posts: 510
|
Re: Handle Restoration
Sponsored Links (Register now to hide all advertisements)
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|