|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
09-21-2010, 10:59 PM | #1 |
Senior Member
Join Date: May 2010
Posts: 330
|
Head marking identification please
Hi Laa,
i am putting in a motor in one of my rigs, and I noticed it has some markings on the head that i had not paid attention to before. I have no background, other than it's been on this engine for a while and seems to run fine.. Here is a picture. it says A6050, has an Mc in a rounded triangle and a 4 below.. Any idea on the make, model or compression? Hope the Pic turns out.. Thanks as always! - Dave in Boise |
09-22-2010, 03:33 AM | #2 |
Senior Member
Join Date: May 2010
Location: Canterbury, New Zealand
Posts: 1,242
|
Re: Head marking identification please
A 6050 is Ford part number for 'cylinder head'. '4' sometimes appears on heads with 'S' which may refer to 'service ' part.
|
Sponsored Links (Register now to hide all advertisements) |
|
09-22-2010, 08:06 PM | #3 |
Senior Member
Join Date: May 2010
Location: Camino, CA.
Posts: 3,086
|
Re: Head marking identification please
It's aftermarket. If you're not building a fine point car, use it.
|
09-22-2010, 08:10 PM | #4 |
Senior Member
Join Date: May 2010
Location: Camino, CA.
Posts: 3,086
|
Re: Head marking identification please
Sponsored Links (Register now to hide all advertisements)
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|