The Ford Barn

B-nut · 08-24-2015, 02:28 PM

Guys I can not seem to find a source for the 1935 backing plate bolts that are needed to finish the final reassembly of my rear axle.These bolts are longer than the later bolts.Would like to get this right.Not seeing then listed by the usual suppliers or even Bob Nacewicz. Any suggestions?

1937pickup · 08-24-2015, 03:49 PM

Give Little Deerborn in Mpls a call-they may be able to help.

JM 35 Sedan · 08-24-2015, 07:30 PM

I have a coffee can of good used '35-'36 nuts and bolts used to fasten backing plates to spindles and rear axel housings. I removed these from rears that I have dismantled over the years. Send me a pm if you would want some of these.

oldandtired · 08-26-2015, 12:32 PM

Sponsored Links (Register now to hide all advertisements)

B-nut...I have some used ones out in the parts bin, but there are 3 different length ones and I cannot remember which ones fit what year. The 3 length ones I have seem to be 1 inch 1 1/4 inch and 1 3/8 inches long.
O&T

08-24-2015, 02:28 PM	#1
B-nut Senior Member Join Date: May 2010 Location: Vt Posts: 231	1935 backing plate bolts Guys I can not seem to find a source for the 1935 backing plate bolts that are needed to finish the final reassembly of my rear axle.These bolts are longer than the later bolts.Would like to get this right.Not seeing then listed by the usual suppliers or even Bob Nacewicz. Any suggestions?

08-24-2015, 03:49 PM	#2
1937pickup Senior Member Join Date: Jul 2012 Posts: 586	Re: 1935 backing plate bolts Give Little Deerborn in Mpls a call-they may be able to help.

08-24-2015, 07:30 PM	#3
JM 35 Sedan Senior Member Join Date: May 2010 Location: Near Rising Sun, Maryland Posts: 10,858	Re: 1935 backing plate bolts I have a coffee can of good used '35-'36 nuts and bolts used to fasten backing plates to spindles and rear axel housings. I removed these from rears that I have dismantled over the years. Send me a pm if you would want some of these. __________________ *John* *"Never give up on what you really want to do. The person with big dreams is more powerful than one with all the facts". Albert Einstein*

08-26-2015, 12:32 PM	#4
oldandtired Senior Member Join Date: May 2010 Location: Edgefield, SC Posts: 810	Re: 1935 backing plate bolts Sponsored Links (Register now to hide all advertisements) B-nut...I have some used ones out in the parts bin, but there are 3 different length ones and I cannot remember which ones fit what year. The 3 length ones I have seem to be 1 inch 1 1/4 inch and 1 3/8 inches long. O&T

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode