11-08-2018, 03:36 PM | #1 |
Senior Member
Join Date: Aug 2017
Location: St. Maries, Idaho
Posts: 162
|
Axle tapper
Can one of you fellas tell me what the tapper specs. are on the hub end of a model A rear axle? Also what is the diameter of the rest of the axle? I don't have one that is accessible to use as a pattern but am needing to make a short stub shaft to go in the lathe. Thanks
|
11-08-2018, 07:49 PM | #2 |
Senior Member
Join Date: Jun 2015
Posts: 1,414
|
Re: Axle tapper
5/8" -18 threads on axle hub end, I believe.
|
Sponsored Links (Register now to hide all advertisements) |
|
11-08-2018, 11:07 PM | #3 |
Member
Join Date: Jan 2013
Location: Mangawhai NZ
Posts: 65
|
Re: Axle tapper
4 degrees should do it starting at 29mm cheers
|
11-10-2018, 09:40 AM | #4 |
Senior Member
Join Date: Nov 2018
Location: Farmington MI
Posts: 281
|
Re: Axle tapper
Sponsored Links (Register now to hide all advertisements)
As for the OP ? … I'm looking at a section of axle shaft, measures 1.165" dia.... or 29 and some mm in OZ Joe B |
Thread Tools | |
Display Modes | |
|
|
Sponsored Links (Register now to hide all advertisements) |
|