31 tudor fender welting

[cfontana]

I did my first model A (30 pickup) over 45 years ago. (still have it) Now that I am retired I picked up a 1931 Tudor that a individual had taken apart done a lot of the restoration and then decided to sell it. I am at the point now where I am putting the rear fenders on. The only place it looks like welting would fit is from the running boards up the splash apron to the body. It seem it would be hard to put it between the fender and the body since the fender is tucked back in the body. Any sites that show where this welting goes and also I have a new fender bolt kit but need a site that shows which types of bolts go where?

[msmaron]

I have a chart and i am looking for it for you

[msmaron]

Ok take a look here for the bolt placement, this should really help you and help with the nuts and bolts in the kit
mark

[msmaron]

Take a look at the fender welting, this should tell you where it is and you have to "tuck" it in there, some folks do place it on the fender with rubber cement to be able to work by themselves but i don't think you will have too.
Good Luck

[mot]

Sponsored Links (Register now to hide all advertisements)

is this what you need?