Spring spreader for reversed eyes

[PeteVS]

I made up a spring spreader for use with reversed eye springs, particularly for a Model A rear. I used two lengths of 3/4 pipe and 3/4 threaded rod, both welded to a pair of 1-1/2" angle iron. I made the pipe portions in two pieces so part of them can be unscrewed for use on a front spring. There are two small plates to clamp the angle iron to the spring leaf. I only intend to use this for the main leaf and assemble the other leaves to it once the main leaf is mounted. The pipes are on 8-1/2" centers to clear the banjo casting.