|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
08-25-2016, 12:16 PM
|
#1 |
|
Senior Member
Join Date: May 2012
Location: Camarillo, CA
Posts: 288
|
Lightened Model A Flywheel
Trying to figure out how much weight to take off a Model A flywheel for my TROG race car. Car will be run in side by side 1/8 mile beach drag races only. Motor will be around 75-85 HP with a B trans case with late model gears. going to run a 9" clutch, 4.11 rear gears.
Would like to make the flywheel as light as is safe and one that will hold up. |
|
|
«
Previous Thread
|
Next Thread
»
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 07:55 PM.