|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
05-06-2018, 03:24 PM | #1 |
Senior Member
Join Date: Jul 2017
Location: Spokane, Washington state
Posts: 250
|
speedo cable grommet- found info to split it per Steve
I have the original mid-late round speedo cable and both ends are bigger than the rubber grommet in the firewall. How do you install the cable from the speedo, along the firewall and little clamp, and then through the grommet to reverse and go back to the torque tube?
Seems like this is a sharp bend as well. I did search posts, but the grommet must need to be cut or something or stretched a lot? thanks question answered.
__________________
68B frame# late May1930, fixed seat, Briggs build plate# & most parts, indicate July, or early Aug. 1930. Last edited by kimeccles; 05-06-2018 at 03:51 PM. Reason: found an old link |
05-06-2018, 03:51 PM | #2 |
BANNED
Join Date: May 2010
Location: Walla Walla, Washington USA
Posts: 6,066
|
Re: speedo cable firewall grommet
|
Sponsored Links (Register now to hide all advertisements) |
|
05-06-2018, 04:00 PM | #3 |
Senior Member
Join Date: Jul 2010
Location: Pennsylvania
Posts: 1,096
|
Re: speedo cable grommet- found info to split it per Steve
I don't know if this is right or not, but on mine, the grommet is cut. I can't see any way of stretching it to get over the fittings.
|
07-04-2018, 09:01 AM | #4 |
Senior Member
Join Date: Dec 2013
Location: The Netherlands
Posts: 387
|
Re: speedo cable grommet- found info to split it per Steve
Sponsored Links (Register now to hide all advertisements)
|
Thread Tools | |
Display Modes | |
|
|
Sponsored Links (Register now to hide all advertisements) |
|