|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
11-22-2010, 01:25 PM | #1 |
Senior Member
Join Date: Nov 2010
Location: Raynham, Mass.
Posts: 583
|
Upholstery question - 30 Coupe Rumble Area
Hello All,
The upholstery panel on the rear of front seat (as viewed from the rumble seat)does not cover the entire area. A 4" gap was left on the bottom. Is this correct? Also, for the rumble panels on either side of the rumble seat, what type of fastener is required to attach to the slat? Thanks in advance, "No one is smarter than everyone" Last edited by brum1; 11-25-2010 at 08:03 PM. |
11-22-2010, 05:33 PM | #2 |
Senior Member
Join Date: May 2010
Location: Naperville, IL
Posts: 1,387
|
Re: Upholstery question - 30 Coupe Rumble Area
The area at the bottom of the back of the rear seat below the upholstery panel is covered with carpet when the car is a Deluxe Coupe. I don't know what is used for the Standard Coupe when it has a rumble seat. The side panels are secured with a slotted wood screw and a finishing washer. Gar Williams
|
Sponsored Links (Register now to hide all advertisements) |
|
11-22-2010, 07:35 PM | #3 |
Senior Member
Join Date: Nov 2010
Location: Raynham, Mass.
Posts: 583
|
Re: Upholstery question - 30 Coupe Rumble Area
Gar-Thanks for the confirmation,
|
10-05-2019, 01:09 PM | #4 | |
Senior Member
Join Date: May 2010
Location: Williamsburg, VA
Posts: 510
|
Re: Upholstery question - 30 Coupe Rumble Area
Sponsored Links (Register now to hide all advertisements)
Quote:
Do you have a picture? Thanks |
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|