|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
06-29-2018, 04:37 PM | #1 |
Member
Join Date: Jan 2014
Location: Asheville NC
Posts: 49
|
34 pinion spline question
I'm putting a Mitchell overdrive in my 34 coupe. It has a 4.11 rear end. When the overdrive arrived it came with a 6-10 spline coupler. My pinion is a six spline so I needed the 6-6 spline coupler. Is six spline correct for a 34\v-8? Or has someone changed it? Don't know what years used six and which ones used ten. I have searched several sites and have mixed results. Thanks, Steve
|
06-29-2018, 05:11 PM | #2 |
Senior Member
Join Date: May 2010
Location: Qld, Australia
Posts: 4,196
|
Re: 34 pinion spline question
It would have been 10 spline originally
Question ,do you have to cut the floor plan to fit the mitchel in? Lawrie |
Sponsored Links (Register now to hide all advertisements) |
|
06-29-2018, 05:42 PM | #3 |
Member
Join Date: Jan 2014
Location: Asheville NC
Posts: 49
|
Re: 34 pinion spline question
Hopefully not! According to their website it requires no body modifications. I'll know when I get the correct coupler. I didn't think the later 6 spline pinion would fit the 33/34 housing with the small pinion bearings? Is it possible to swap them? Steve
|
06-29-2018, 05:57 PM | #4 |
Senior Member
Join Date: Jun 2010
Location: San Antonio, Texas
Posts: 16,371
|
Re: 34 pinion spline question
Sponsored Links (Register now to hide all advertisements)
Mitchel should be able to do a 6-spline shaft since there stuff is all modification anyway. |
Thread Tools | |
Display Modes | |
|
|
Sponsored Links (Register now to hide all advertisements) |
|