The Ford Barn

James G. · 08-24-2018, 04:23 PM

I'd like my starter push rod to be a bit longer/taller. With the soundproofing material, floor mat, it is quite short to push. What is the original rod size/thread, etc. Likely I could even make one. What are my options, what have you done with success.
All comments welcomed.
Thanks,
Jim G.

jw hash · 08-25-2018, 01:41 AM

5/16 fine thread. put a lock nut on the rod so you don`t have to screw it in so far.

James G. · 08-25-2018, 03:05 PM

Sponsored Links (Register now to hide all advertisements)

Thanks, that was easy.

08-24-2018, 04:23 PM	#1
James G. Senior Member Join Date: May 2010 Location: maryland Posts: 183	Starter push Rod I'd like my starter push rod to be a bit longer/taller. With the soundproofing material, floor mat, it is quite short to push. What is the original rod size/thread, etc. Likely I could even make one. What are my options, what have you done with success. All comments welcomed. Thanks, Jim G.

08-25-2018, 01:41 AM	#2
jw hash Senior Member Join Date: May 2010 Location: Auburn Washington Posts: 2,552	Re: Starter push Rod 5/16 fine thread. put a lock nut on the rod so you don`t have to screw it in so far.

08-25-2018, 03:05 PM	#3
James G. Senior Member Join Date: May 2010 Location: maryland Posts: 183	Thanks, that was easy! Sponsored Links (Register now to hide all advertisements) Thanks, that was easy.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode