06-18-2013, 10:20 AM | #1 |
Senior Member
Join Date: May 2010
Location: Michigan
Posts: 505
|
Intake Gasket
Am changing the intake gasket on my 8-BA and noticed that it doesn't quite line up on some of the ports on the intake and the block. In other words, there is some overlap into some of the ports. Not much but maybe about a 1/32 of an inch. It would seem to me that this would interrupt the flow to some degree, especially on the intakes. So my question is: Is it worth the time to trim the gasket so it fits each port perfectly or am I just being too picky. It's a Felpro gasket.
|
06-18-2013, 10:39 AM | #2 |
Senior Member
Join Date: May 2010
Location: Kokomo, Indiana
Posts: 1,731
|
Re: Intake Gasket
There's nothing wrong with being precise. That said, if your engine is stock, I doubt you'd notice any difference . . . but YOU would know it was "right". My $.02 worth.
__________________
Henry |
Sponsored Links (Register now to hide all advertisements) |
|
06-18-2013, 08:23 PM | #3 |
Senior Member
Join Date: May 2010
Location: Michigan
Posts: 505
|
Re: Intake Gasket
Thanks Henry, it's not a stock engine.
|
06-18-2013, 08:59 PM | #4 |
Senior Member
Join Date: May 2010
Location: ManchVegas, New Hampshah
Posts: 1,589
|
Re: Intake Gasket
Sponsored Links (Register now to hide all advertisements)
|
Thread Tools | |
Display Modes | |
|
|
Sponsored Links (Register now to hide all advertisements) |
|