|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
04-09-2018, 07:27 AM | #1 |
Senior Member
Join Date: Feb 2011
Location: Lincoln, Nebraska
Posts: 1,908
|
Intake manifold bolt finish
What is the proper finish for the two bolts holding the intake manifold to the exhaust manifold?
__________________
Dave / Lincoln Nebraska |
04-09-2018, 08:03 AM | #2 |
Senior Member
Join Date: May 2010
Location: Young Harris, GA
Posts: 1,818
|
Re: Intake manifold bolt finish
The bolts between the manifolds and the lock washers were unfinished.
This information is on the very last page of Area 1 - Engine Compartment, in the Restoration Guidelines book. All of the finishes are there. Have fun!
__________________
Jim Cannon Former MAFCA Technical Director "Have a Model A day!" |
Sponsored Links (Register now to hide all advertisements) |
|
04-09-2018, 08:04 AM | #3 |
Senior Member
Join Date: Aug 2012
Location: South East Wisconsin
Posts: 1,279
|
Re: Intake manifold bolt finish
Dave: JS sez "bolts between manifolds, U. According to the key, that means unfinished. mike
|
04-09-2018, 08:06 AM | #4 |
Senior Member
Join Date: Aug 2012
Location: South East Wisconsin
Posts: 1,279
|
Re: Intake manifold bolt finish
OK. Jim beat me to it. The wonders of the internet. LOL
|
04-09-2018, 01:16 PM | #5 |
Senior Member
Join Date: Feb 2011
Location: Lincoln, Nebraska
Posts: 1,908
|
Re: Intake manifold bolt finish
Thank you gentlemen.
__________________
Dave / Lincoln Nebraska |
04-09-2018, 05:25 PM | #6 |
Senior Member
|
Re: Intake manifold bolt finish
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|