|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
08-07-2019, 03:57 PM | #1 |
Senior Member
Join Date: May 2010
Posts: 886
|
valve guide re- bush and tooling
Can any one help guide me as to what tooling I need to add bronze bushings to 239/255 valve guides, what seals ,bushings are suitable and what brands/part numbers etc., till now I have been knurling my used guides ,I would exchange them but I have a few buckets full of used guides I think it would be more cost effective to add bronze bushings myself as I have lathes and time to do it in house, I have used silver seal and Regis for most of my tools, any other preferred tool suppliers out there for such supplies ?
|
08-07-2019, 05:36 PM | #2 |
Senior Member
Join Date: May 2010
Location: Canada Where it snows
Posts: 2,058
|
Re: valve guide re- bush and tooling
Sponsored Links (Register now to hide all advertisements)
If not it is a fair investment in tools to get the minimum tooling for 11/32" valves. Boring tool for bronze. Reamers or carbide balls for correct sizing,installation tooling,removal tool,trim to length tooling after installation.Flex hone Home made tooling to hold guide while installing liners . Regis Silver Seal Goodsen all have the tooling. I have some new never used 11/32" stuff that is surplus to me. What is your location? https://goodson.com/blogs/goodson-ga...e-guide-liners R Last edited by Ronnie; 08-07-2019 at 05:44 PM. |
Sponsored Links (Register now to hide all advertisements) |
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|