Go Back   The Ford Barn > General Discussion > Model A (1928-31)

Sponsored Links (Register now to hide all advertisements)

Reply
 
Thread Tools Display Modes
Old 05-16-2018, 06:56 AM   #1
aermotor
Senior Member
 
Join Date: Mar 2015
Location: Greenville, SC
Posts: 657
Default Roof wadding

In the last 2 years I have covered or helped cover 3 tops purchased from L.B.
One mat was thin cotton that you could read a newspaper through, one was about 1/4" thick cotton mat, and the last was a thick blue fabric of some kind of man-made material. Presently we are working on the thin cotton and blue material on 2 different cars. The 1/4" mat was completed about a year ago and presented no problems. Little nervous about the thin mat and thicker blue cloth mat. Any comments on the different mats? No, foam was never considered. L.B. basically says: it is what it is.

John
aermotor is offline   Reply With Quote
Old 05-16-2018, 08:20 AM   #2
Big hammer
Senior Member
 
Join Date: Jun 2014
Location: Land of Lincoln
Posts: 1,751
Default Re: Roof wadding

I used three wool blankets, one cut for the opening, the other two under two full width. It maybe a little puffy for some, I’am happy with it!
__________________
Don't force it with a little hammer tap, tap, tap
get a bigger hammer tap done
Big hammer is offline   Reply With Quote
Sponsored Links (Register now to hide all advertisements)
Old 05-16-2018, 08:40 AM   #3
BILL WILLIAMSON
Senior Member
 
BILL WILLIAMSON's Avatar
 
Join Date: Dec 2010
Location: FRESNO, CA
Posts: 12,216
Default Re: Roof wadding

I've seen some roofs, where they drove the tacks in TOO TIGHT & made "puckered" areas.
Chief used Horseshoe Nails, for temporary holding, until final stretching & nailing. They come out easily & are VERY SHARP & easy to drive in.
He & I used that NO LABEL, canned roofing tar, to coat OLD roofs & with a length way brushing with a stiff OLD brush, it looked like LONG GRAIN COPRA---LOL---Once, we did a roof from a NEW Cotton Sack & finished it off with the above coating. Better than a KICK in the head or a sharp stick in yo' EYE! Po' Folks had Po' ways! For padding, we used QUILTING Cotton, "maybe" 2 layers??? I don't remember for SURE??? We used an OLD Straight Razor, for "safe" trimming.
Bill Black
__________________
"THE ASSISTANT GURU OF STUFF"

Last edited by BILL WILLIAMSON; 05-16-2018 at 08:46 AM. Reason: ADDING TIP#19
BILL WILLIAMSON is offline   Reply With Quote
Old 05-16-2018, 08:43 AM   #4
1930artdeco
Senior Member
 
1930artdeco's Avatar
 
Join Date: May 2010
Location: Oakland, CA
Posts: 2,389
Default Re: Roof wadding

Dad used house insulation and it really keeps the car cool or hot depending on the day.

Mike
__________________
1930 TownSedan (Briggs)
Still learning after all these years....
1930artdeco is offline   Reply With Quote
Old 05-17-2018, 06:57 PM   #5
redmodelt
Senior Member
 
redmodelt's Avatar
 
Join Date: May 2010
Location: Portland OR
Posts: 3,724
Default Re: Roof wadding

ditto on the quilting padding, only I used the synthetic. Comes in different thickness and if it does get wet wont hold the water like cotton would.
__________________
I know the voices aren't real but damn they have some good ideas!
redmodelt is offline   Reply With Quote
Old 05-17-2018, 11:47 PM   #6
pbishop
Member
 
Join Date: Apr 2011
Location: Wimauma, Florida
Posts: 59
Default Re: Roof wadding

Go to Marco’s ‘ www.abarnyard.com . Click the bottom right arrow to ‘Begin the Tour’. Then select ‘The Workshop’. In the list of subjects click on ‘Installing a Closed Car Roof’. Marco lists the components and ‘step-by-step’ instructions as to how to install the ‘soft top’.


I bought my ‘kit’ from Snyders and installed it over 25 years ago. Following Marco’s directions the soft top is still ‘completely tight’ as it was when I did the job.

As I remember, the kit padding was ” thick. You can always get more at a fabric store (take a piece to show them). I followed Marco’s advice and covered the ‘chicken wire (stapled in tight)’ with a layer of fabric (stapled in tight). Then I laid the padding on top of that. This insured that the padding did not sink into the chicken-wire. Remember, the cotton-padding is very porous and will compress

The KEY is to ‘DO THE INSTALL ON A HOT DAY and in DIRECT SUN LIGHJT’. That way everything is fully expanded and can only get tighter / contract in cold weather. 25 years on and I can still bounce a coin off of the top.
pbishop is offline   Reply With Quote
Old 05-18-2018, 08:02 AM   #7
Smurkey
Senior Member
 
Smurkey's Avatar
 
Join Date: Nov 2011
Location: Esko, MN
Posts: 257
Default Re: Roof wadding

I used indoor/outdoor carpeting of a low pile. Has worked excellent for years now. Smooth as a billiard table up there.
Smurkey is offline   Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 04:53 AM.