The Ford Barn

forever4 · 05-08-2010, 06:15 PM

http://www.fordgarage.com

qzjrd5 · 05-08-2010, 06:29 PM

I'm in!!!

Mike

hotcoupe · 05-08-2010, 06:32 PM

i`d like to join, where do i send the $50.00 membership fee?

dudley32 · 05-08-2010, 06:51 PM

got a B in my roadster...can I join ??

sacattack · 05-08-2010, 10:12 PM

hey im in here sacattack32 light 001.jpg

32 ar 007.jpg

Copy of 32 ar 010.jpg

Copy (2) of 32 ar 009.jpg

Chris · 05-08-2010, 11:09 PM

Sponsored Links (Register now to hide all advertisements)

I dig it!

Pat/Ohio · 05-09-2010, 11:24 AM

Hi Vince, I'm here too! Pat

Charlie Stephens · 05-09-2010, 05:55 PM

Count me in. I restored a '32 roadster as a Model B in the seventies. It cost less but was harder to do than a V8. Nobody knew what the correct parts looked like at that time. I still have the car. I installed a 4 cylinder Mercruiser Marine (181 cubic inch) in the eighties and it is still there (no cutting or welding required, just 4 3/8 bolt holes for the front engine mounts). I have an original V8 under the bench. It will either get the original V8 or a Model B at some time in the future. I also have a very tired but never restored 4 cylinder 4 door sedan that is a future project.

Charlie Stephens

Bruce Lancaster · 05-09-2010, 06:08 PM

Count me in. First order of business...sue the V8 club. Those bloodsuckers are charging us for eight cylinders when we clearly are only firing on four. Blatant extortion, unfair business practices, and discrimination against minorities!

kelley's restoration · 05-09-2010, 08:53 PM

i want in
i love the 4 bangers
tk

Manuel · 05-09-2010, 10:46 PM

Hey Bruce, do we get a refund??

flatheadute1934 · 05-10-2010, 08:14 AM

All the cars I have found so far have been V8, would not change a Model B and do have a Model A

jerseyboy · 05-10-2010, 08:48 AM

I'm in! Thanks for putting this up Vince!

ford33 · 05-10-2010, 11:21 AM

I tried to join. Don't know if I'm in or not.
Fred

Bob in Ga · 05-15-2010, 08:03 AM

This should be a good learning experience, have had a B engine in this Model A for 12 yrs. Good touring engine. Have a question - need to replace the clutch/throwout bearing. Have not found any info on whether there is a difference between the A&B? Thanks - Bob

Bob in Ga · 05-15-2010, 06:37 PM

Thanks for the info, definitely hear new parts are very poor quality.
Thanks

05-08-2010, 06:15 PM	#1
forever4 BANNED Join Date: May 2010 Posts: 116	http://www.fordgarage.com http://www.fordgarage.com Last edited by forever4; 09-03-2016 at 04:20 PM.

05-08-2010, 06:29 PM	#2
qzjrd5 Member Join Date: May 2010 Location: Troy, MI Posts: 32	Re: 1932-34 Model B Four Cylinder Group started! I'm in!!! Mike

05-08-2010, 06:32 PM	#3
hotcoupe Senior Member Join Date: May 2010 Location: imperial,mo Posts: 694	Re: 1932-34 Model B Four Cylinder Group started! i`d like to join, where do i send the $50.00 membership fee?

05-08-2010, 06:51 PM	#4
dudley32 Senior Member Join Date: May 2010 Location: fayetteville n.c. Posts: 139	Re: 1932-34 Model B Four Cylinder Group started! got a B in my roadster...can I join ??

05-08-2010, 10:12 PM	#5
sacattack Junior Member Join Date: May 2010 Location: courtenay b.c. can Posts: 12	Re: 1932-34 Model B Four Cylinder Group started! hey im in here sacattack32 light 001.jpg 32 ar 007.jpg Copy of 32 ar 010.jpg Copy (2) of 32 ar 009.jpg

05-08-2010, 11:09 PM	#6
Chris Senior Member Join Date: May 2010 Location: Spokane, WA Posts: 2,976	Re: 1932-34 Model B Four Cylinder Group started! Sponsored Links (Register now to hide all advertisements) I dig it!

05-09-2010, 05:55 PM	#8
Charlie Stephens Senior Member Join Date: May 2010 Location: Southern California Posts: 7,032	Re: 1932-34 Model B Four Cylinder Group started! Count me in. I restored a '32 roadster as a Model B in the seventies. It cost less but was harder to do than a V8. Nobody knew what the correct parts looked like at that time. I still have the car. I installed a 4 cylinder Mercruiser Marine (181 cubic inch) in the eighties and it is still there (no cutting or welding required, just 4 3/8 bolt holes for the front engine mounts). I have an original V8 under the bench. It will either get the original V8 or a Model B at some time in the future. I also have a very tired but never restored 4 cylinder 4 door sedan that is a future project. Charlie Stephens

05-09-2010, 06:08 PM	#9
Bruce Lancaster Member Emeritus Join Date: May 2010 Location: Madison, NJ Posts: 5,230	Re: 1932-34 Model B Four Cylinder Group started! Count me in. First order of business...sue the V8 club. Those bloodsuckers are charging us for eight cylinders when we clearly are only firing on four. Blatant extortion, unfair business practices, and discrimination against minorities!

05-09-2010, 08:53 PM	#10
kelley's restoration Senior Member Join Date: May 2010 Location: 60046 Posts: 888	Re: 1932-34 Model B Four Cylinder Group started! i want in i love the 4 bangers tk

05-09-2010, 10:46 PM	#11
Manuel Senior Member Join Date: May 2010 Location: ACT Australia Posts: 506	Re: 1932-34 Model B Four Cylinder Group started! Hey Bruce, do we get a refund??

05-10-2010, 08:14 AM	#12
flatheadute1934 BANNED Join Date: May 2010 Location: Brooklin Posts: 205	Re: 1932-34 Model B Four Cylinder Group started! All the cars I have found so far have been V8, would not change a Model B and do have a Model A

05-10-2010, 08:48 AM	#13
jerseyboy Senior Member Join Date: May 2010 Location: Northwest CT Posts: 503	Re: 1932-34 Model B Four Cylinder Group started! I'm in! Thanks for putting this up Vince!

05-10-2010, 11:21 AM	#14
ford33 Member Join Date: May 2010 Location: Sask. Canada Posts: 97	Re: 1932-34 Model B Four Cylinder Group started! I tried to join. Don't know if I'm in or not. Fred Last edited by ford33; 05-08-2021 at 01:45 PM.

05-15-2010, 08:03 AM	#15
Bob in Ga Junior Member Join Date: May 2010 Location: Columbus, Ga Posts: 15	Re: 1932-34 Model B Four Cylinder Group started! This should be a good learning experience, have had a B engine in this Model A for 12 yrs. Good touring engine. Have a question - need to replace the clutch/throwout bearing. Have not found any info on whether there is a difference between the A&B? Thanks - Bob

05-15-2010, 06:37 PM	#16
Bob in Ga Junior Member Join Date: May 2010 Location: Columbus, Ga Posts: 15	Re: 1932-34 Model B Four Cylinder Group started! Thanks for the info, definitely hear new parts are very poor quality. Thanks