Go Back   The Ford Barn > General Discussion > Model A (1928-31)

Sponsored Links (Register now to hide all advertisements)

Reply
 
Thread Tools Display Modes
Old 07-24-2015, 10:42 PM   #1
Drive Shaft Dave
Senior Member
 
Join Date: Dec 2011
Location: New hope Minnesota
Posts: 742
Default running board bolts

What bolts should be used at the front of the running board to the rear of the fender? 30 coupe .early.
Drive Shaft Dave is offline   Reply With Quote
Old 07-24-2015, 11:20 PM   #2
Bill Cilker
Senior Member
 
Bill Cilker's Avatar
 
Join Date: Apr 2011
Location: Milpitas, CA
Posts: 396
Default Re: running board bolts

Dave
January through September 1930 - Bolts were 5/16”-18 x 3/4", Bolts heads were 7/16” hex (3/8” hex used on occasion).
__________________
Bill Cilker, Jr
Unrestored 190A Victoria
45B, 160B & 189A
Victoria Association President
Bill Cilker is offline   Reply With Quote
Sponsored Links (Register now to hide all advertisements)
Old 07-26-2015, 10:34 PM   #3
Drive Shaft Dave
Senior Member
 
Join Date: Dec 2011
Location: New hope Minnesota
Posts: 742
Default Re: running board bolts

Sponsored Links (Register now to hide all advertisements)
Thanks, Bill.
Drive Shaft Dave is offline   Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 11:10 AM.