|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
 |
|
Thread Tools | Display Modes |
11-06-2019, 08:22 PM
|
#1 |
|
Senior Member
Join Date: May 2010
Location: Stratham, NH
Posts: 233
|
35 Horn Projector Screens
Has anyone had the experience of replacing the screens in their horn projectors?
I know they're available in repro. if you've done this what does the process involve. Any info will be appreciated. Peter |
|
|
|
11-07-2019, 12:14 AM
|
#2 |
|
Senior Member
Join Date: May 2010
Location: Masterton, New Zealand
Posts: 3,834
|
Re: 35 Horn Projector Screens
If you remove the three screws holding the projector to base of horn, you can simply reach down and push the old screen out. Installation of the new screen is the opposite; by pushing the centre of the new screen outwards, you can 'bow' it so it's slightly smaller than the opening, push it into place and expand it into place in the groove by pushing the centre in the opposite way.
__________________
Unfortunately, two half wits don't make a whole wit! |
|
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
11-07-2019, 06:00 AM
|
#3 |
|
Senior Member
Join Date: May 2010
Location: Stratham, NH
Posts: 233
|
Re: 35 Horn Projector Screens
Sponsored Links (Register now to hide all advertisements)
and want to replace the screens while I'm at it. Peter |
|
|
|
|
«
Previous Thread
|
Next Thread
»
Linear Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 06:06 AM.