Go Back   The Ford Barn > General Discussion > Model A (1928-31)

Sponsored Links (Register now to hide all advertisements)

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 04-13-2016, 02:36 PM   #1
Don/WI
Senior Member
 
Join Date: May 2010
Location: Kaukauna, Wisconsin
Posts: 392
Default Manifold machining

I recently attempted to machine a manifold assembly. I mounted the assembly using the carburetor mounting to fasten it to an angle plate on my milling machine. In doing so I noticed that the manifold mounting surface is not perpendicular to the carburetor surface. I measure approximately 0.024" difference from one side to the other on the 2" width. Does anyone know if there is an angle at which the manifold should be mounted when machining or will machining them perpendicular to the carburetor cause any problem? I would appreciate any information that I receive. Thanks. Don/WI
Don/WI is offline   Reply With Quote
 

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 07:45 AM.