Go Back   The Ford Barn > General Discussion > Early V8 (1932-53)

Sponsored Links (Register now to hide all advertisements)

Reply
 
Thread Tools Display Modes
Old 04-29-2020, 02:24 PM   #1
BUBBAS IGNITION
Senior Member
 
BUBBAS IGNITION's Avatar
 
Join Date: May 2010
Location: SPEEDWAY INDIANA
Posts: 3,994
Default Helmet tip of the day .....

Just a small tip to save ya tons of time when rebuilding the helmet distributor .
Clean up backing point plate , coat with a good prime ( suggest transstar black)
then oil the adjusting screws and spin with electric screwdriver assuring they are loose and free.
You wont believe how much time this will save ya when setting the distributor up !!!!
Attached Images
File Type: jpg IMG_3638.jpg (66.1 KB, 39 views)
__________________
If it Makes Spark, we do it !!!!
www.bubbasignition.com
jimlinder@juno.com
BUBBAS IGNITION is offline   Reply With Quote
Old 04-29-2020, 02:25 PM   #2
BUBBAS IGNITION
Senior Member
 
BUBBAS IGNITION's Avatar
 
Join Date: May 2010
Location: SPEEDWAY INDIANA
Posts: 3,994
Default Re: Helmet tip of the day .....

the plate and screws
Attached Images
File Type: jpg IMG_3637.jpg (72.6 KB, 79 views)
__________________
If it Makes Spark, we do it !!!!
www.bubbasignition.com
jimlinder@juno.com
BUBBAS IGNITION is offline   Reply With Quote
Sponsored Links (Register now to hide all advertisements)
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 03:14 AM.