|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
07-27-2010, 04:47 PM | #1 |
Senior Member
Join Date: May 2010
Location: VA
Posts: 1,410
|
Horn Brush Holders
My horn wants to honk continuously. The external wiring checks out, but there is a short to ground from the terminals. This goes away when I remove the brush holders. My brush holder screws have a fiber washer under the head and a larger one between the frame and the brush holder. There isn't anything there to keep the shank of the screw from contacting the ID of the hole in the frame. Looking at the parts suppliers' online catalogs, I don't see that there is an isolator for the ID of the hole in the frame. I thought I might try to centralize the screw in the hole, but that doesn't seem like it was the factory solution.
Am I barking up the wrong tree? Any suggestions? |
07-29-2010, 10:45 AM | #2 |
Senior Member
Join Date: May 2010
Location: VA
Posts: 1,410
|
Re: Horn Brush Holders
Sponsored Links (Register now to hide all advertisements)
|
Sponsored Links (Register now to hide all advertisements) |
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|