|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
04-12-2019, 08:46 PM | #1 |
Senior Member
Join Date: May 2010
Location: Lynden, Wa
Posts: 3,550
|
Help she no go....
OK I finally got done putting Barb back together and she is liquored up oil and water with no leaks-so far . Went to fire her up and got a wimpy pop and then nothing. So here is what I have done so far:
-Timed her three times (according to Les)-the dimple is just past the timing pin hole. -The rotor lines up with #1 (modern upper plate) and I have 6v with a meter at the points. I also hear and see a spark when I open and close the points. -I pulled the plugs to make rotation easier and they were bone dry and I have been using starter fluid. -I have gas going to the carb as I cracked the line and it started to leak. -She does crank Any other ideas? Tomorrow I will pull a plug and see if I get a spark at the plug. Thanks, Mike
__________________
1930 TownSedan (Briggs) 1957 Country Sedan |
|
|
Sponsored Links (Register now to hide all advertisements) |
|