Go Back   The Ford Barn > The Archives > Early V8

Sponsored Links (Register now to hide all advertisements)

 
 
Thread Tools Display Modes
Old 03-30-2005, 01:58 PM   #1
Guest
 
Posts: n/a
Default Claying the heads




I might be the only guy on this forum that doesn't know but I doubt it.Would someone explain step by step the procedure for claying heads? Or suggest a book? Do you torque down head bolts or studs? Where do you buy clay,like an art supply store? Is the desired clearance on valves .50 and pistons .100? Do you measure the clay with a micrometer after compressing it? So many questions. Will someone have pity on the this ignorant soul?





 
Old 03-30-2005, 02:46 PM   #2
Guest
 
Posts: n/a
Default Re: Claying the heads







You aren't the only one who needs an explanation on this question.





 
Sponsored Links (Register now to hide all advertisements)
Old 03-30-2005, 03:37 PM   #3
Guest
 
Posts: n/a
Default Re: Claying the heads

Sponsored Links (Register now to hide all advertisements)






You don't need to torque the heads to spec, just to about 45 ft. lbs. Modeling clay is what most people use. Get it from an arts and crafts store. Be sure to smear some motor oil or grease on the pistons and valve heads to keep the clay from sticking to them. Rotate the engine through a couple of complete revolutions by hand to compress the clay, then remove the head and measure the thickness witha a machinist's ruler. Check the pistons in several different areas, the domes and and around the edges. .050" to .100" over the pistons is good, but performance suffers a bit with piston to head clearnce over .050". Valve clearance shoud be at least .040" with a a gasket thickness of .55", a bit more is better for flow. You can reuse the gaskets.





 
 

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 03:05 AM.