|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
09-30-2021, 07:42 PM | #1 |
Member
Join Date: Jul 2013
Location: Western WA state
Posts: 63
|
31 rdstr rumble fasteners
Howdy,
Quit as an employee so consequently while not on the front burner the model a project is at least back on the stove! Just finished installing new floor panels Two quick questions; What fasteners are used on the outboard ends of the rumble curved inner panel if any? (3 @ each side?) Same question for the rumble pivot bracket to body. This unit was pretty much assembled with hardware store fasteners. Thanks, Gary |
09-30-2021, 08:02 PM | #2 |
Senior Member
Join Date: May 2010
Location: Auburn Washington
Posts: 2,552
|
Re: 31 rdstr rumble fasteners
the three fasteners for the panel is 1/4 20 x 5/8 stove bolts with lock washers and square nuts. the bolts for the rumble hinge brackets are 5/16 NF X 3/4 bolts with lock washers and one 1/4 20 X 5/8 stove bolt with lock washer that goes in the bottom of the drip rail.
|
Sponsored Links (Register now to hide all advertisements) |
|
09-30-2021, 10:31 PM | #3 |
Member
Join Date: Jul 2013
Location: Western WA state
Posts: 63
|
Re: 31 rdstr rumble fasteners
Stove bolt = slotted round head?
|
10-01-2021, 07:40 AM | #4 |
Senior Member
Join Date: May 2010
Location: Auburn Washington
Posts: 2,552
|
Re: 31 rdstr rumble fasteners
Sponsored Links (Register now to hide all advertisements)
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|