|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
06-16-2020, 07:32 AM | #1 |
Senior Member
Join Date: Oct 2016
Location: harpursville ny
Posts: 1,040
|
39 transmission leak
After finally getting engine and tranny installed I found tranny leak in back where pin goes through the two shafts. It is leaking on the right side of pin which is loose, i can move it left to right. It doesnt seem this pin would wear but why would it leak and would a new pin stop it? It looks like I could push out the old pin with a new one as I really dont want to take everything apart again. I may try to seal pin with permatex but don't think it will work. I know others have had the same problem and has anyone been able to fix this leak with tranny in car?
|
06-16-2020, 08:59 AM | #2 |
Senior Member
Join Date: May 2010
Location: Snohomish,WA
Posts: 1,030
|
Re: 39 transmission leak
Are you sure that is where the leak is? I was looking at trans parts the other night and noticed Michael at Next Gen Auto is offering a sealed rear bearing for the rear output to help eliminate leaks. It sounds like you are probably right about the shaft leaking but seeing that bearing offered made me wonder if it was dripping downward toward the shaft
|
Sponsored Links (Register now to hide all advertisements) |
|
06-16-2020, 09:08 AM | #3 |
Senior Member
Join Date: May 2010
Location: Star, MS
Posts: 4,024
|
Re: 39 transmission leak
I think you will find that the leak is between the housing and shafts that hold the cluster gear and the reverse idler. It is very common for them to leak there. Some have cut a groove in the shafts for o-rings where they seat in the housing.
|
06-16-2020, 09:34 AM | #4 |
Senior Member
Join Date: Oct 2016
Location: harpursville ny
Posts: 1,040
|
Re: 39 transmission leak
The leak is deffently coming the pin, I have car on lift and been watching it for a week. I rebuilt this tranny a few years ago and did seal the ends of the shafts with rtv and they are not leaking. I wish I paid attention to that pin at that time.
|
06-16-2020, 10:00 AM | #5 |
Senior Member
Join Date: May 2010
Location: upstate SC
Posts: 2,963
|
Re: 39 transmission leak
remove the pin, clean it and the hole thru the trans with brake cleaner, coat the pin/hole with non hardening Permatex #2 I think and then put the pin back in. I did this with my 41 truck and it seems to work. The leak really is the shafts coming thru the case but this worked for me
|
06-16-2020, 12:41 PM | #6 |
Senior Member
Join Date: May 2010
Location: Star, MS
Posts: 4,024
|
Re: 39 transmission leak
Sponsored Links (Register now to hide all advertisements)
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|