03-13-2015, 07:06 PM | #1 |
Member
Join Date: Jun 2010
Location: Utica, KY
Posts: 81
|
Engine Angle
Building an engine run stand, suggestions for proper angle of the engine to return the oil to the pan and oil pump. What I did. Top of carb set as close to zero front to rear and side to side.
Bob Last edited by Ironrod; 12-12-2016 at 09:30 AM. |
03-14-2015, 07:47 AM | #2 |
Senior Member
Join Date: May 2010
Location: Northeast Pennsylvania
Posts: 1,582
|
Re: Engine Angle
I'd say that your intake manifold angle will determine the best angle for your stand, because ideally your carburetor should be level to the earth.
Torque tube cars didn't angle the engines, open drive cars did. I don't think the oil pan or pump really cares whether an engine angle differs by a few degrees. |
Sponsored Links (Register now to hide all advertisements) |
|
03-14-2015, 10:36 AM | #3 |
Member
Join Date: Jun 2010
Location: Utica, KY
Posts: 81
|
Re: Engine Angle
Sponsored Links (Register now to hide all advertisements)
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|