|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
10-05-2018, 10:28 PM | #1 |
Senior Member
Join Date: May 2010
Posts: 157
|
Transmission Work Stand
I've been helped several times from this site that I thought I would pass this information on to those working on rebuilding their transmissions. I ran across this a while ago, and from memory I constructed this transmission stand with perhaps a few improvements.
Some of you may be familiar with this transmission stand made simply from 3/4" pipe fittings. It worked great for me and made the rebuilding assembly of the transmission very easy. |
10-05-2018, 11:02 PM | #2 |
Senior Member
Join Date: May 2010
Posts: 107
|
Re: Transmission Work Stand
Looks handy - good work.
Glen |
Sponsored Links (Register now to hide all advertisements) |
|
10-06-2018, 11:18 AM | #3 |
Senior Member
Join Date: May 2010
Location: Santee, California
Posts: 3,505
|
Re: Transmission Work Stand
Handy, but all that pipe can be expensive.
|
10-06-2018, 02:14 PM | #4 |
Senior Member
Join Date: Nov 2010
Location: Anchorage, Alaska
Posts: 9,115
|
Re: Transmission Work Stand
But for guys like me that don't weld, --
__________________
Alaskan A's Antique Auto Mushers of Alaska Model A Ford Club of America Model A Restorers Club Antique Automobile Club of America Mullins Owner's Club |
10-06-2018, 04:58 PM | #5 |
Senior Member
Join Date: May 2010
Location: Raleigh, NC
Posts: 510
|
Re: Transmission Work Stand
to save pipe expenses...I have seen this same idea done with just the 3/4 downpipe coming off the trans drain hole with a T fitting at the bottom and clamped in a vise.
|
10-06-2018, 07:12 PM | #6 |
Senior Member
Join Date: Jul 2013
Location: La Porte, IN
Posts: 143
|
Re: Transmission Work Stand
Sponsored Links (Register now to hide all advertisements)
|
10-06-2018, 09:08 PM | #7 |
Senior Member
Join Date: May 2010
Location: Mpls, MN
Posts: 27,582
|
Re: Transmission Work Stand
I use a short piece of pipe and fit the lower end into a 2 x 12 about a foot long.
Cheap and easy tranny holder. |
10-06-2018, 10:13 PM | #8 |
Senior Member
Join Date: May 2010
Location: Tucson, Arizona
Posts: 374
|
Re: Transmission Work Stand
I do the same, with a hole in the 2 X 12 sose I can direct solvent used to preliminarily clean the gearbox (before disassembly) into a metal pan below for waste removal.
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|