Go Back   The Ford Barn > General Discussion > Early V8 (1932-53)

Sponsored Links (Register now to hide all advertisements)

Reply
 
Thread Tools Display Modes
Old 01-21-2019, 09:57 PM   #1
Fourdy
Senior Member
 
Fourdy's Avatar
 
Join Date: May 2010
Location: Port Townsend, WA
Posts: 601
Default Stock oil filter?

I am preparing to start my engine for break-in and have a question about the filter. The filter body has a tight rubber seal on the top and bottom that appears to seal against the inside tube. I have a new seal for the lid but don't know if anything more is required as far as seals go.

Thanks and anxious for the help.

Fourdy
Attached Images
File Type: jpg DSC_1829 copy.jpg (53.6 KB, 46 views)
Fourdy is offline   Reply With Quote
Old 01-21-2019, 11:03 PM   #2
41ford1
Senior Member
 
41ford1's Avatar
 
Join Date: May 2010
Location: ManchVegas, New Hampshah
Posts: 1,589
Default Re: Stock oil filter?

That is all you need. Just make sure the cover and body surfaces are clean. Remove the old gasket from the cover and install the new one in its place.
__________________
You are never to old to enjoy your childhood.

Forty1fordpickup on the HAMB.
41ford1 is offline   Reply With Quote
Sponsored Links (Register now to hide all advertisements)
Old 01-21-2019, 11:24 PM   #3
Fourdy
Senior Member
 
Fourdy's Avatar
 
Join Date: May 2010
Location: Port Townsend, WA
Posts: 601
Default Re: Stock oil filter?

Sponsored Links (Register now to hide all advertisements)
Thank you for your reply. Everything is all cleaned up and ready to go then.

Fourdy
Fourdy is offline   Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 03:05 AM.