|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
11-03-2014, 09:30 PM
|
#1 |
|
Member
Join Date: Nov 2010
Posts: 33
|
2 piece front pulley
I have a new 2 piece pulley that has the 2 tabs that line up.The seal sleeve part of it has square cut tangs on it and the pulley part is cut so it has rounded corners and doesn`t fit tight against the sleeve.There`s about an 1/8 inch gap between pulley and sleeve.Is this suppose to be this way to press them together or do I have to file the pulley tangs to fit the sleeve?
|
|
|
«
Previous Thread
|
Next Thread
»
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 04:31 PM.