|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
 |
|
Thread Tools | Display Modes |
11-06-2015, 01:56 PM
|
#1 |
|
Member
Join Date: Aug 2010
Posts: 55
|
28/29 Coupe/Tudor garnish door pull trim
Could you use a 30/31 Tudor garnish door pull trim on a 28/29 Coupe/Tudor door? Of course I realize that it wouldn't be accurate for a restoration, but could it be done just to get by? It appears that the holes line up, but I haven't put screws in to confirm.
|
|
|
|
11-06-2015, 05:12 PM
|
#2 |
|
Senior Member
Join Date: May 2010
Location: Georgetown Divide Kelsey ca
Posts: 868
|
Re: 28/29 Coupe/Tudor garnish door pull trim
Not the same length . I'm on the way out to the barn I'll measure some . The 1930 coupe garnish are shorter by 3/4" - 7/8" and the screw holes won't line up .
__________________
Dennis in Kelsey ca Last edited by Dennis Pereira; 11-06-2015 at 05:36 PM. |
|
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
11-06-2015, 08:12 PM
|
#3 |
|
Member
Join Date: Aug 2010
Posts: 55
|
Re: 28/29 Coupe/Tudor garnish door pull trim
Dennis, I know that the 30/31 Coupe trim are shorter.
The 28/29 Coupe/Tudor trim is slightly shorter than the 30/31 Tudor trim, but the 30/31 Tudor trim seems to line up with the holes on the 28/29 Coupe/Tudor doors. |
|
|
|
|
11-06-2015, 08:58 PM
|
#4 |
|
Senior Member
Join Date: May 2010
Location: Georgetown Divide Kelsey ca
Posts: 868
|
Re: 28/29 Coupe/Tudor garnish door pull trim
Sponsored Links (Register now to hide all advertisements)
__________________
Dennis in Kelsey ca |
|
|
|
|
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Display Modes | |
Linear Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 08:06 AM.