Ford holley carb fuel inlet fitting

[1931flathead]

Look for part number or if anyone has them for sale thanks

[farmertom]

Napa

[scicala]

Mike's carburetor parts has them too.

Sal

https://www.carburetor-parts.com/Bra...80_p_2408.html

[1931flathead]

Ok I thought they were special cause for a 94 holley carb if you look at this picture

Never to old to learn

[Ziggster]

Haha! I'm glad I wasn't the only who had difficulty figuring the "mystery" Holley/Ford fitting. My saga...


https://www.fordbarn.com/forum/showt...ght=Carburetor

[scicala]

Sponsored Links (Register now to hide all advertisements)

Originally Posted by 1931flathead

Ok I thought they were special cause for a 94 holley carb if you look at this picture

Never to old to learn

The three fittings you posted a picture of, seal on the taper at the end like the original factory fuel line on earlier carbs. The fitting I supplied info on, seals with a fiber washer under the hex.

Sal

[1931flathead]

Ok thanks

[1931flathead]

Any one have a napa number the napa I have just young kids don't know what to look for thanks

[Charlie ny]

These are repair fittings, upon a time easy to get NAPA etc.....not on the active here
in Buffalo N.Y. anymore. I'll buy a swap meet 94 if has that fitting on it. The fitting from Mikes is for a flare seal not a ferrule
Charlie ny

[1931flathead]

Yes I need them for a 5/16 fuel line with a flare fitting just like the one in the first picture

[1941Pony]

Speedway has then but they are aluminum, not brass.

[Ziggster]

If this is what you are looking for, this may help. It is from a Parker catalogue. At my local Napa store (Canada) they said they that deal with Fairview Fittings, but no matter, they should be able to cross reference it to the Parker P/N: 48IFHD-5-4

[Ziggster]

Link to catalogue.

http://www.parkerstore.jp/phj/catalo..._EN/Book-E.pdf

[scicala]

The part # 48IFHD-5-4 appears to be a male 1/4 NPT thread. 1931flathead needs the male end to be a 1/2-20 straight thread.

Sal

[Ziggster]

You are correct Sal. My apologies as I thought the NPT was just a reference as I know the thread for the carb is 1/2"-20. From the cross sectio pic of the fitting, it shows a straight thread and not NPT. Did some more looking and just cannot find the correct fitting, not even from the Holley website.

[Ziggster]

What about is using this fitting (46F-5-4), and then inserting the one I previously mentioned? A search on this reveals all sorts of "MacGyver" solutions including retapping the 1/2"-20 straight thread to a NPT.

[scicala]

Originally Posted by Ziggster

You are correct Sal. My apologies as I thought the NPT was just a reference as I know the thread for the carb is 1/2"-20. From the cross sectio pic of the fitting, it shows a straight thread and not NPT. Did some more looking and just cannot find the correct fitting, not even from the Holley website.

No Need for apologies. We're all just trying to help.

Sal

[1931flathead]

https://www.summitracing.com/parts/edd-265500

This should be the one

[1931flathead]

I found what I needed at part store if some wants the number I have it

A 5/16 brake or fuel line will screw into it