Go Back   The Ford Barn > General Discussion > Early V8 (1932-53)

Sponsored Links (Register now to hide all advertisements)

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 09-20-2016, 10:55 PM   #11
40larry
Senior Member
 
Join Date: May 2010
Location: Northridge, CA
Posts: 236
Default Re: '40 Pickup full restoration project

Mike:
Looks good. I can see that heater switch is located incorrectly. Check the factory photo in Towne's book on page 40 and you see it located slightly left of the throttle rod on bottom of dash. Also your tailpipe should be a 91C part which ends several inches after the rear hanger. You can see this on the factory photo shown in the Mack Hils book. This will be easy to fix by cutting off the excess length...........Larry
40larry is offline   Reply With Quote
 


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 04:47 AM.