|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
07-10-2013, 12:08 AM | #1 |
Senior Member
Join Date: Dec 2010
Location: Verdi, Nevada
Posts: 166
|
Increasing flow on stock oil pump
Anyone had experience with increasing flow on a oil pump. I am using an early pump housing with the 9/16 passage and relieving a new 1/2 inch diameter shaft to 3/8 as was the original shaft. Any other ideas of what else might be done. I have adapted the pump by closing off the top of the housing with a bushing and routing the oil flow though a remote filter from the fitting on the side of the block and back into the side cover into the oil channel. Just wondering if anyone else as attempted this modification.
Thanks Rick Jensen |
07-10-2013, 02:00 AM | #2 |
Senior Member
Join Date: May 2010
Location: Oregon
Posts: 5,941
|
Re: Increasing flow on stock oil pump
Sponsored Links (Register now to hide all advertisements)
Last edited by J Franklin; 07-11-2013 at 03:48 PM. |
Sponsored Links (Register now to hide all advertisements) |
|
Thread Tools | |
Display Modes | |
|
|
Sponsored Links (Register now to hide all advertisements) |
|