10-02-2010, 02:49 PM | #1 |
Senior Member
Join Date: May 2010
Location: Southern OR.
Posts: 222
|
35 p/u dash ?
I put the screws in order in an egg crate; Now I just don't know the order! this is the second set of screws I have put in the forward side holding the dash in, and now wonder if they go inside along the bottom, inside seams to have a larger hole? Won't stop the world from turning but would like to get it correct. Thanks as always
|
10-02-2010, 03:15 PM | #2 |
Senior Member
Join Date: May 2010
Location: Above the gnat line in Georgia
Posts: 7,009
|
Re: 35 p/u dash ?
They are the same size screws. (Don't recall the exact size at the moment.) Holes may have been wallowed out over the years. Mine were in my 35. You have the ones shown in correctly. The ones that go on the bottom edge of the belt rail have a leather/rubber washer under them.
|
Sponsored Links (Register now to hide all advertisements) |
|
10-02-2010, 03:23 PM | #3 | |
Senior Member
Join Date: May 2010
Location: Southern OR.
Posts: 222
|
Re: 35 p/u dash ?
Quote:
|
|
10-02-2010, 08:06 PM | #4 |
Senior Member
Join Date: May 2010
Location: Above the gnat line in Georgia
Posts: 7,009
|
Re: 35 p/u dash ?
Yes, washers go on the 6 inside at the bottom of the dash belt rail/molding
|
10-02-2010, 08:21 PM | #5 |
Senior Member
Join Date: May 2010
Location: Southern OR.
Posts: 222
|
Re: 35 p/u dash ?
Thanks Lawson, Rather then pull the six screws, I left them and got 6 more washers at the plumbing supply store and added them to the (belt rail)? I am good to go and can see how the holes could be wallowed out; That took a good part of the day to line the little crank handle up.
|
10-03-2010, 12:42 PM | #6 |
Senior Member
Join Date: May 2010
Location: Above the gnat line in Georgia
Posts: 7,009
|
Re: 35 p/u dash ?
Sponsored Links (Register now to hide all advertisements)
|
Thread Tools | |
Display Modes | |
|
|
Sponsored Links (Register now to hide all advertisements) |
|