|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
11-08-2013, 10:59 PM | #1 |
Senior Member
Join Date: May 2010
Location: Corona, CA
Posts: 185
|
Drive Shaft Angle Question
My generic question concerns almost any early ford with a closed driveline. Given that the rear end angles up toward the trans at about 3 to 5 degrees, where is that angle established? Is the angle built into the crossmember or is it built into the spring hangers? Some other means?
|
11-08-2013, 11:16 PM | #2 |
Senior Member
Join Date: May 2010
Location: Kerrville, Tx
Posts: 2,769
|
Re: Drive Shaft Angle Question
Sponsored Links (Register now to hide all advertisements)
|
Sponsored Links (Register now to hide all advertisements) |
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|