|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
05-26-2011, 09:50 PM | #1 |
Senior Member
Join Date: May 2010
Location: West Coast Canada B.C. Interior
Posts: 332
|
1934 Ford Ignition Switch wiring Question..
I am rewiring my 34 Ford 4 Dr Sedan, can someone tell me where the wires go and how many connections there are on the back of the ignition/steering lock sw, a picture would be nice, thanks guys ...
|
05-26-2011, 11:30 PM | #2 |
Senior Member
Join Date: May 2010
Location: At my kitchen table in Santa Rosa, Ca
Posts: 2,903
|
Re: 1934 Ford Ignition Switch wiring Question..
my 36 only has 2 wires
__________________
If it would have been a snake it would have bit ya! i can't spell my way out of a paper bag! |
Sponsored Links (Register now to hide all advertisements) |
|
05-27-2011, 03:00 AM | #3 |
Senior Member
Join Date: May 2010
Location: Oamaru, New Zealand
Posts: 419
|
Re: 1934 Ford Ignition Switch wiring Question..
Should have one 'hot' wire coming in to the switch on one terminal, and 1 wire on the other terminal, to the resistor, and then to the coil.
|
05-27-2011, 12:05 PM | #4 |
Member Emeritus
Join Date: May 2010
Location: Madison, NJ
Posts: 5,230
|
Re: 1934 Ford Ignition Switch wiring Question..
Sponsored Links (Register now to hide all advertisements)
Don't discard the original contact plate...from what I've seen I'd clean up the contacts and keep it in preference to the repros I have bought. |
|
|
Sponsored Links (Register now to hide all advertisements) |
|