09-30-2015, 12:59 AM
|
#1 |
|
Senior Member
Join Date: Sep 2010
Location: South Coast NSW Australia
Posts: 2,596
|
conrod
Is this a model A conrod?
Have they all the same markings as this one ? About what diameter is the big end , considering a crank could be ground ? What is length from big end centre to gudgeon centre ? 
|
|
|
|
09-30-2015, 01:33 AM
|
#2 |
|
Senior Member
Join Date: Nov 2011
Location: Queensland Australia
Posts: 640
|
Re: conrod
Crankshaft journal end is 1.5", Piston/wrist pin end 1" and length 7.5" centre to centre. Doesn't look like Model A to me. It doesn't have a oil dipper on the big end cap.
__________________
Adjust your points with gentle blows of a 2 pound hammer 
|
|
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
09-30-2015, 09:19 AM
|
#3 |
|
Member Emeritus
Join Date: May 2010
Location: Madison, NJ
Posts: 5,230
|
Re: conrod
Sponsored Links (Register now to hide all advertisements)
Looks like the part # is on it, but I can't quite read the prefix which will tell what the thing is for...can you post the writing? |
|
|
|
 |
«
Previous Thread
|
Next Thread
»
Linear Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 07:30 AM.