03-23-2005, 02:23 PM | #1 |
Guest
Posts: n/a
|
block
I tore down a flathead and ran a tap throu the block headbolts. Did i ruin it. I did not know this was a no no. Can i correct it. |
03-23-2005, 04:17 PM | #2 |
Guest
Posts: n/a
|
Re: block
If that screws up a block then I've screwed up a lot of blocks. I always do it. |
Sponsored Links (Register now to hide all advertisements) |
|
03-23-2005, 05:00 PM | #3 |
Guest
Posts: n/a
|
Re: block
Running a tap through them probably wont hurt. The stock studs and holes have a stronger rolled thread, not a sharp edged thread from a tap & die. |
03-23-2005, 05:51 PM | #4 |
Guest
Posts: n/a
|
Re: block
Didn't hurt mine either. r_ |
03-24-2005, 01:39 PM | #5 |
Guest
Posts: n/a
|
Re: block
no problem when i did mine |
03-25-2005, 06:01 AM | #6 |
Guest
Posts: n/a
|
Re: block
Sponsored Links (Register now to hide all advertisements)
I think you have a much better chance of getting a good seal with CLEAN holes and a good sealer. Frank |
|
|
Sponsored Links (Register now to hide all advertisements) |
|