Go Back   The Ford Barn > General Discussion > Early V8 (1932-53)

Sponsored Links (Register now to hide all advertisements)

Reply
 
Thread Tools Display Modes
Old 09-28-2015, 05:49 PM   #1
George49Ford
Senior Member
 
George49Ford's Avatar
 
Join Date: May 2010
Location: Carson City, NV
Posts: 179
Question '49 Coil Wires - 8BA

Rookie question here. I just put in replacement distributor and coil (not new). Coil terminals are marked + and -. I made an assumption that + is the "hotwire" from ignition and - goes to the distributor. I can't find it in my (well worn) Green Book, and all my wiring diagrams don't specify which is which. Haven't tried to start it yet, but did I get the wires right, or possibly, does even make any difference. Thank You for all replies.
George49Ford is offline   Reply With Quote
Old 09-28-2015, 05:55 PM   #2
Bob C
Senior Member
 
Join Date: May 2010
Location: So Cal
Posts: 8,712
Default Re: '49 Coil Wires - 8BA

+ is positive so if you have original 6V positive ground system the
wire from the distributor would go to the coil +.

Bob
Bob C is offline   Reply With Quote
Sponsored Links (Register now to hide all advertisements)
Old 09-28-2015, 10:03 PM   #3
George49Ford
Senior Member
 
George49Ford's Avatar
 
Join Date: May 2010
Location: Carson City, NV
Posts: 179
Default Re: '49 Coil Wires - 8BA

Great. Thank You!
George49Ford is offline   Reply With Quote
Old 09-29-2015, 09:11 AM   #4
JSeery
Member Emeritus
 
JSeery's Avatar
 
Join Date: Nov 2012
Location: Wichita KS
Posts: 16,132
Default Re: '49 Coil Wires - 8BA

Yep, polarity of the coil should match the polarity of the battery. If you are running positive ground at the battery, then the negative would be the "hot" wire to the coil. As Bob said, the (+) would connect to the distributor and the (-) would connect to the ignition (battery).
JSeery is offline   Reply With Quote
Old 12-19-2015, 06:10 PM   #5
billfish
Senior Member
 
billfish's Avatar
 
Join Date: Jan 2014
Location: egg harbor twp nj
Posts: 303
Default Re: '49 Coil Wires - 8BA

I just came across this post and had an experience recently when I installed the coil in my stock 6 volt pos gr 8ba backwards. It did seem to run and idle ok but after it warmed up it would miss and run bad especially under load. Took me a while to figure it out. I was surprised it ran at all.
billfish is offline   Reply With Quote
Old 12-19-2015, 10:06 PM   #6
JSeery
Member Emeritus
 
JSeery's Avatar
 
Join Date: Nov 2012
Location: Wichita KS
Posts: 16,132
Default Re: '49 Coil Wires - 8BA

Sponsored Links (Register now to hide all advertisements)
They will work wired backwards, but at a lower level (greatly decreased performance).
JSeery is offline   Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 02:51 PM.