|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
10-09-2018, 10:06 AM | #1 |
Junior Member
Join Date: Oct 2018
Location: South Jersey
Posts: 13
|
Rebuilding a distributor
I have a good housing that I bought after ours was found to be so rusted that it's only value is as a paper weight. So I am looking to buy:
Upper plate Lower plate Points Condenser Hardware pack Rotor Cap Distributor body Coil "Wires" I checked prices between several vendors and I have a list compiled of who has what and their costs. And from working on old cars for years and buying from some of these vendors, I see Mac's is still higher than the others. Nice to see there are some constants in the world today. Am I missing anything? Later! Mr. Ed
__________________
1951 F-1, 351W, C-4, Henry. 1993 Mustang 5.0 LX convertible, Sally. 2006 Jeep Grand Cherokee Laredo, Herman. |
10-09-2018, 10:23 AM | #2 |
Senior Member
Join Date: May 2010
Location: So Cal
Posts: 8,749
|
Re: Rebuilding a distributor
Bushings, shaft, Stipe distributor cam, get A&L condenser.
Bob |
Sponsored Links (Register now to hide all advertisements) |
|
10-10-2018, 09:30 AM | #3 |
Senior Member
Join Date: Jun 2015
Location: Red Deer, Alberta
Posts: 5,043
|
Re: Rebuilding a distributor
https://www.brattons.com/distributor...ock-parts.html
Or: https://www.brattons.com/distributor...dern-part.html
__________________
If you don't hear a rumor by 10 AM, start one!. Got my education out behind the barn! |
10-10-2018, 01:30 PM | #4 |
Junior Member
Join Date: Oct 2018
Location: South Jersey
Posts: 13
|
Re: Rebuilding a distributor
Thanks for the replies.
Later! Mr. Ed
__________________
1951 F-1, 351W, C-4, Henry. 1993 Mustang 5.0 LX convertible, Sally. 2006 Jeep Grand Cherokee Laredo, Herman. |
10-10-2018, 06:53 PM | #5 |
Senior Member
Join Date: May 2010
Location: Minnesota
Posts: 198
|
Re: Rebuilding a distributor
Sponsored Links (Register now to hide all advertisements)
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|