The Ford Barn

Habusailor · 02-15-2021, 10:03 AM

Sponsored Links (Register now to hide all advertisements)

I bought a rebuilt 60 horse this winter. It was done many years ago and sat in a machine shop during that time. I pulled the heads and it looks like it was run on a test stand and put away, cylinder walls and piston tops look fresh. I am going to pull the intake and pan check for stuck valves and inspect the bearings for deterioration. Is Reds the best place for new gasket set? Also i dont plan to pull any studs from the block, is there anything I can put around the base of the studs to help prevent possible seepage or do I just go through breakin procedure and if necessary go to stop leak?

Sent from my SM-T550 using Tapatalk

02-15-2021, 10:03 AM	#1
Habusailor Senior Member Join Date: Dec 2016 Location: Fargo North Dakota Posts: 264	60hp Sponsored Links (Register now to hide all advertisements) I bought a rebuilt 60 horse this winter. It was done many years ago and sat in a machine shop during that time. I pulled the heads and it looks like it was run on a test stand and put away, cylinder walls and piston tops look fresh. I am going to pull the intake and pan check for stuck valves and inspect the bearings for deterioration. Is Reds the best place for new gasket set? Also i dont plan to pull any studs from the block, is there anything I can put around the base of the studs to help prevent possible seepage or do I just go through breakin procedure and if necessary go to stop leak? Sent from my SM-T550 using Tapatalk