The Ford Barn

jay/wis · 11-06-2013, 12:10 PM

what would be the ideal lube for the horn and light switch rod on my 35 pu, so that the rod does'nt turn when the steering wheel is turned? thanks

1932BB · 11-06-2013, 12:14 PM

The rod may be bent and contacting the side of the shaft.

Lawson Cox · 11-06-2013, 12:58 PM

Sponsored Links (Register now to hide all advertisements)

I agree with 1932BB The rod is probably bent just a tad and is binding on the tube. Check it out, and don't bend the rod too much. It won't hurt anything to put a wee tad of grease on the rod where it is rubbing on the tube. Good luck and keep us posted. What about posting a picture of your 35 PU.

11-06-2013, 12:10 PM	#1
jay/wis Junior Member Join Date: May 2010 Location: Green Bay Posts: 15	light switch and horn rod what would be the ideal lube for the horn and light switch rod on my 35 pu, so that the rod does'nt turn when the steering wheel is turned? thanks

11-06-2013, 12:14 PM	#2
1932BB Senior Member Join Date: Jan 2012 Location: Marquette Mich. Posts: 125	Re: light switch and horn rod The rod may be bent and contacting the side of the shaft.

11-06-2013, 12:58 PM	#3
Lawson Cox Senior Member Join Date: May 2010 Location: Above the gnat line in Georgia Posts: 7,009	Re: light switch and horn rod Sponsored Links (Register now to hide all advertisements) I agree with 1932BB The rod is probably bent just a tad and is binding on the tube. Check it out, and don't bend the rod too much. It won't hurt anything to put a wee tad of grease on the rod where it is rubbing on the tube. Good luck and keep us posted. What about posting a picture of your 35 PU. __________________ Life is like a roll of toilet paper. The closer to the end, the faster it goes. It is better to be seen, than viewed. "We sleep safe in our beds because rough men stand ready in the night to visit violence on those who would do us harm".

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode