|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
01-31-2018, 08:35 PM | #1 |
Senior Member
Join Date: May 2010
Location: Middlebury, CT
Posts: 780
|
Engine test stand modification
Hi Barners,
I have an engine test stand that was designed to hold a Short Block Chevy engine (pardon me). I need to rework all the mounts. What angle does the engine sit when fully mounted? I logically think that it should be level with the ground but just want to hear your opinions. I know the Ford 351 engine in my ski boat sits at 15 degrees....BUT that's a boat. Thanks, Bruce/CT
__________________
Failure is simply the opportunity to begin again, this time more intelligently.......Henry Ford |
01-31-2018, 09:00 PM | #2 |
Senior Member
Join Date: May 2010
Location: Santee, California
Posts: 3,505
|
Re: Engine test stand modification
Go by the intake manifold carburetor flange. The carb base should be level to ground.
|
Sponsored Links (Register now to hide all advertisements) |
|
01-31-2018, 09:19 PM | #3 |
Senior Member
Join Date: May 2010
Location: Ashland KY
Posts: 1,159
|
Re: Engine test stand modification
Had my 37 almost level and oil was coming out of vent hole in oil pan,using 4 qts oil,had to lower engine rear a full bubble with level on rear of bell housing,to keep oil from from coming out.
__________________
DON P |
02-01-2018, 09:36 PM | #4 |
Senior Member
Join Date: May 2010
Location: Santee, California
Posts: 3,505
|
Re: Engine test stand modification
|
02-01-2018, 11:51 PM | #5 |
Senior Member
Join Date: May 2010
Location: East Hartford, Ct
Posts: 5,898
|
Re: Engine test stand modification
Sponsored Links (Register now to hide all advertisements)
Some earlier engines do not have any inclination built into the intake manifold so using the carb mount to set level could be in error.(the carb mount would not be level )
__________________
DON'T RECALL DOING SOMETHING FOR MYSELF BASED ON SOMEONE ELSE'S LIKES OR DISLIKES |
|
|
Sponsored Links (Register now to hide all advertisements) |
|