|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
04-25-2012, 01:51 PM | #1 |
Junior Member
Join Date: May 2010
Location: Austin, Texas
Posts: 7
|
1930 Phaeton floor parts question.
I need to replace the rear seat base and floors in a 30 Standard Phaeton (35B) but all I see in the Macs/Snyders/Mike's catalogs are for the 28/29 model....
So is this the same on the 30/31 models? If there is a difference, can someone point it out or is this something I can modify these parts fairly easily to fit (via cut & weld)? Thanks in advance! -Clif |
04-25-2012, 06:20 PM | #2 |
Senior Member
Join Date: May 2010
Location: Eastern Tennessee
Posts: 11,508
|
Re: 1930 Phaeton floor parts question.
With modifications you can use them. Most that I have used do not come with the "hump" and that must be spot-welded in and ordered as a seperate piece. On my website is a picture of a '30 Phaeton that we did with all new lower sheetmetal.
|
Sponsored Links (Register now to hide all advertisements) |
|
04-26-2012, 11:22 AM | #3 |
Junior Member
Join Date: May 2010
Location: Austin, Texas
Posts: 7
|
Re: 1930 Phaeton floor parts question.
Sponsored Links (Register now to hide all advertisements)
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|