Go Back   The Ford Barn > General Discussion > Model A (1928-31)

Sponsored Links (Register now to hide all advertisements)

Reply
 
Thread Tools Display Modes
Old 09-26-2013, 07:15 PM   #1
johnsor
Senior Member
 
Join Date: May 2010
Location: Spooner, Wisconsin
Posts: 242
Default Door Hinge

Is it possible to adjust the front door hinge on my 31 "A"? I installed a clamp-on type mirror on the front edge of the door and now I have to slam it hard to latch it fully. I would like to move the hinge out just a tad.
johnsor is offline   Reply With Quote
Old 09-26-2013, 07:23 PM   #2
Mitch//pa
BANNED
 
Join Date: May 2010
Location: Bucks County, PA
Posts: 11,454
Default Re: Door Hinge

what about a hinge pin mirror.... forget about moving the hinge. i guess you dont care about your paint putting a clamp mirror on
my guess is you went that route because your hinge pins are seized
Mitch//pa is offline   Reply With Quote
Sponsored Links (Register now to hide all advertisements)
Old 09-26-2013, 07:49 PM   #3
johnsor
Senior Member
 
Join Date: May 2010
Location: Spooner, Wisconsin
Posts: 242
Default Re: Door Hinge

Sponsored Links (Register now to hide all advertisements)
That's right. I didn't want to "muck-up" my nice paint job with a large hammer/punch or torch around the frozen hinge pin. Any hidden scratch under the mirror base (that you can't see) is O.K. I did find that the mirror would not tip in far enough to see directly behind, so I bought a $3.00 convex 3-1/2" stick on mirror at O'Reilly's and stuck it on the flat 4" mirror. Works great and I can even view the normal blind spot fine.
johnsor is offline   Reply With Quote
Reply


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 05:19 AM.