|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
12-02-2021, 08:52 AM | #1 |
Senior Member
Join Date: Mar 2016
Location: Montana
Posts: 185
|
Fitting top wood on 29 CCPU
This is maybe a stupid question but do You normally have to do alot of custom fitting on the top wood on a 29 CCPU? My side wood above the door going from the rear cab corners are sitting down tight on the rear cab corners but the rear cab top wood doesnt fit down tight on the upper portion of the rear cab panel. I have the cab fitting good on the frame. The doors fit pretty good and the cab is square. It seems I need to trim the side wood on the rear corners so the back cross wood will fit down tighter. I have a 1/2" gap between the top of the back panel to the cross wood. Any Ideas?
|
12-02-2021, 09:07 AM | #2 | |
Senior Member
Join Date: May 2010
Location: Eastern Tennessee
Posts: 11,508
|
Re: Fitting top wood on 29 CCPU
Quote:
. |
|
Sponsored Links (Register now to hide all advertisements) |
|
12-02-2021, 10:16 AM | #3 |
Senior Member
Join Date: Mar 2016
Location: Montana
Posts: 185
|
Re: Fitting top wood on 29 CCPU
I'am using a commercial kit from one of companies making the kits.
|
12-02-2021, 10:59 AM | #4 |
Senior Member
Join Date: May 2010
Location: Durango CO
Posts: 1,309
|
Re: Fitting top wood on 29 CCPU
Sponsored Links (Register now to hide all advertisements)
__________________
No restorable Model A's were harmed in the building of this truck! |
|
|
Sponsored Links (Register now to hide all advertisements) |
|