The Ford Barn

Graham Freeman · 09-29-2019, 04:38 PM

I have a Roy Nacewicz 33/34 body mounting kit.
The fastenings supplied for the wheelhouse to frame kickup (2 per side) do not appear to be correct.
Supplied are 5/16" - 7/8" carriage bolts where the heads are supposed to face outwards.
Looking at original vehicles that I have seen they all have hex bolts with large
1 1/2" washers on the outside which fit into slight recesses.
If the washer system is correct? the finish would be cadmium?

Thanks
Graham

DavidG · 09-29-2019, 06:37 PM

From all the originals I've seen and taken apart, Roy's carriage bolts are correct, with the head on the outside. That included a Canadian '33 with the rest being of U.S. manufacture.

Graham Freeman · 09-29-2019, 07:02 PM

Mine is of U.S. origin.
Of several original vehicles I have seen here in NZ they all have bolts and washers.
There has been no repair work done on the inner wheelhouse areas.
Surely if carriage bolts were used in this location there would be a square hole for the shoulder to fit into so the nut could be tightened.
My one has round holes, that is why I am asking.
Anyone have a photo they could post?

DavidG · 09-29-2019, 07:50 PM

I know it sounds a bit odd, but that's what they used, just like through the rear of the scuff plate at the B pillar (at least on the fifteen I've owned over the years).

stangblue · 10-02-2019, 07:22 AM

Here is a picture of a 34.

stangblue · 10-03-2019, 08:23 AM

Sponsored Links (Register now to hide all advertisements)

34 Ford rear inner fender

09-29-2019, 04:38 PM	#1
Graham Freeman Senior Member Join Date: May 2010 Location: New Zealand Posts: 298	33/34 body fixing query. I have a Roy Nacewicz 33/34 body mounting kit. The fastenings supplied for the wheelhouse to frame kickup (2 per side) do not appear to be correct. Supplied are 5/16" - 7/8" carriage bolts where the heads are supposed to face outwards. Looking at original vehicles that I have seen they all have hex bolts with large 1 1/2" washers on the outside which fit into slight recesses. If the washer system is correct? the finish would be cadmium? Thanks Graham

09-29-2019, 06:37 PM	#2
DavidG Senior Member Join Date: May 2010 Location: southeastern Michigan Posts: 10,101	Re: 33/34 body fixing query. From all the originals I've seen and taken apart, Roy's carriage bolts are correct, with the head on the outside. That included a Canadian '33 with the rest being of U.S. manufacture.

09-29-2019, 07:02 PM	#3
Graham Freeman Senior Member Join Date: May 2010 Location: New Zealand Posts: 298	Re: 33/34 body fixing query. Mine is of U.S. origin. Of several original vehicles I have seen here in NZ they all have bolts and washers. There has been no repair work done on the inner wheelhouse areas. Surely if carriage bolts were used in this location there would be a square hole for the shoulder to fit into so the nut could be tightened. My one has round holes, that is why I am asking. Anyone have a photo they could post?

09-29-2019, 07:50 PM	#4
DavidG Senior Member Join Date: May 2010 Location: southeastern Michigan Posts: 10,101	Re: 33/34 body fixing query. I know it sounds a bit odd, but that's what they used, just like through the rear of the scuff plate at the B pillar (at least on the fifteen I've owned over the years).