|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
08-03-2021, 09:41 PM | #1 |
Senior Member
Join Date: May 2010
Location: Ohio
Posts: 819
|
Rumble and Trunk Lid Handle Locations
Hi, for a 30-31 Rumble Lid versus a Trunk lid: What is the dimension from the edge of the lid to the handle hole?
Can anyone confirm that for the Rumble lid the dimension from the top edge to the center of the hole is 2.75"? Can anyone confirm that for the Trunk lid the dimension from the bottom edge to the center of the hole is 1.75"? If these are incorrect dimensions, please provide the correct dimensions. Thank you! |
08-04-2021, 01:40 PM | #2 |
Senior Member
Join Date: May 2010
Posts: 1,641
|
Re: Rumble and Trunk Lid Handle Locations
My rumble handle is closer to 2 - 5/8" from edge FWIW.
|
Sponsored Links (Register now to hide all advertisements) |
|
08-04-2021, 01:57 PM | #3 |
Senior Member
Join Date: May 2010
Location: Oregon
Posts: 1,374
|
Re: Rumble and Trunk Lid Handle Locations
My '31 trunk handle is 1.75" from edge to the hole center.
|
08-06-2021, 07:05 PM | #4 |
Senior Member
Join Date: May 2010
Location: Ohio
Posts: 819
|
Re: Rumble and Trunk Lid Handle Locations
Thanks, that helps.
|
08-06-2021, 08:33 PM | #5 |
Senior Member
Join Date: May 2010
Location: South East NJ
Posts: 3,398
|
Re: Rumble and Trunk Lid Handle Locations
Use the latch to get the exact dimensions.
The hole needs to be placed to match where the latch position will be. It is important to note that the collar of the latch MUST touch the underside of the rumble lid panel. Otherwise the handle will pull the outer sheet metal down causing a low spot. |
08-10-2021, 10:58 AM | #6 |
Senior Member
Join Date: Feb 2019
Location: Erie Pa
Posts: 691
|
Re: Rumble and Trunk Lid Handle Locations
Sponsored Links (Register now to hide all advertisements)
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|