Go Back   The Ford Barn > General Discussion > Model A (1928-31)

Sponsored Links (Register now to hide all advertisements)

Reply
 
Thread Tools Display Modes
Old 08-24-2018, 04:23 PM   #1
James G.
Senior Member
 
Join Date: May 2010
Location: maryland
Posts: 163
Default Starter push Rod

I'd like my starter push rod to be a bit longer/taller. With the soundproofing material, floor mat, it is quite short to push. What is the original rod size/thread, etc. Likely I could even make one. What are my options, what have you done with success.
All comments welcomed.
Thanks,
Jim G.
James G. is offline   Reply With Quote
Old 08-25-2018, 01:41 AM   #2
jw hash
Senior Member
 
jw hash's Avatar
 
Join Date: May 2010
Location: Auburn Washington
Posts: 2,049
Default Re: Starter push Rod

5/16 fine thread. put a lock nut on the rod so you don`t have to screw it in so far.
jw hash is offline   Reply With Quote
Sponsored Links (Register now to hide all advertisements)
Old 08-25-2018, 03:05 PM   #3
James G.
Senior Member
 
Join Date: May 2010
Location: maryland
Posts: 163
Default Thanks, that was easy!

Thanks, that was easy.
James G. is offline   Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 01:12 AM.