|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
03-14-2011, 01:56 PM | #1 |
Junior Member
Join Date: May 2010
Location: Battle Ground, WA
Posts: 10
|
Rear sheet metal for '36 convertible sedan trunkback
City:
Battle Ground
State:
Washington
I need a rear pan for my '36 convertible sedan (the trunk-back model). Unlike nearly all the other '36 cars, there is no aftermarket rear pan available so I'm looking for someone who is parting out one of these cars. I may have to build one, but would like to avoid that if I can. I would take all the body from the doors back if you don't want to sell the pan separately.
The picture below shows the bondo-filled piece that I need to replace. If you have the sheet metal I need, please send me a message or call me at 360-921-9935. Thanks. Lonnie Last edited by Mossback; 05-03-2011 at 11:41 AM. Reason: Added an option to take more of body. |
03-27-2011, 04:25 PM | #2 |
Junior Member
Join Date: May 2010
Location: Battle Ground, WA
Posts: 10
|
Re: Rear sheet metal for '36 convertible sedan trunkback
ttt
|
Sponsored Links (Register now to hide all advertisements) |
|
04-01-2011, 11:22 PM | #3 |
Junior Member
Join Date: May 2010
Location: Battle Ground, WA
Posts: 10
|
Re: Rear sheet metal for '36 convertible sedan trunkback
Sponsored Links (Register now to hide all advertisements)
|
Thread Tools | |
Display Modes | |
|
|
Sponsored Links (Register now to hide all advertisements) |
|